Anti-DLL1 Antibody Picoband®

Figure 1. Western blot analysis of DLL1 using anti-DLL1 antibody (A02513-1).
Electrophoresis was performed on a 5-20% SDS-PAGE gel at 70V (Stacking gel) / 90V (Resolving gel) for 2-3 hours. The sample well of each lane was loaded with 50ug of sample under reducing conditions.
Lane 1: human HELA whole cell lysates,
Lane 2: monkey COS-7 whole cell lysates,
Lane 3: huamn Jurkat whole cell lysates,
Lane 4: huamn Raji whole cell lysates,
Lane 5: human SW620 whole cell lysates,
Lane 6: human HepG2 whole cell lysates,
Lane 7: human U20S whole cell lysates,
Lane 8: rat heart tissue lysates,
Lane 9: rat C6 whole cell lysates,
Lane 10: mouse heart tissue lysates,
Lane 11: mouse Neuro-2a whole cell lysates,
Lane 12: mouse RAW264.7 whole cell lysates,
After Electrophoresis, proteins were transferred to a Nitrocellulose membrane at 150mA for 50-90 minutes. Blocked the membrane with 5% Non-fat Milk/ TBS for 1.5 hour at RT. The membrane was incubated with rabbit anti-DLL1 antigen affinity purified polyclonal antibody (Catalog # A02513-1) at 0.25 μg/mL overnight at 4°C, then washed with TBS-0.1%Tween 3 times with 5 minutes each and probed with a goat anti-rabbit IgG-HRP secondary antibody at a dilution of 1:10000 for 1.5 hour at RT. The signal is developed using an Enhanced Chemiluminescent detection (ECL) kit (Catalog # EK1002) with Tanon 5200 system. A specific band was detected for DLL1 at approximately 78KD. The expected band size for DLL1 is at 78KD.

Figure 2. IHC analysis of DLL1 using anti-DLL1 antibody (A02513-1).
DLL1 was detected in paraffin-embedded section of human placenta tissue. Heat mediated antigen retrieval was performed in EDTA buffer (pH8.0, epitope retrieval solution). The tissue section was blocked with 10% goat serum. The tissue section was then incubated with 1μg/ml rabbit anti-DLL1 Antibody (A02513-1) overnight at 4°C. Biotinylated goat anti-rabbit IgG was used as secondary antibody and incubated for 30 minutes at 37°C. The tissue section was developed using Strepavidin-Biotin-Complex (SABC) (Catalog # SA1022) with DAB as the chromogen.

Figure 3. IF analysis of DLL1 using anti-DLL1 antibody (A02513-1).
DLL1 was detected in immunocytochemical section of A549 cells. Enzyme antigen retrieval was performed using IHC enzyme antigen retrieval reagent (AR0022) for 15 mins. The cells were blocked with 10% goat serum. And then incubated with 4μg/mL rabbit anti-DLL1 Antibody (A02513-1) overnight at 4°C. DyLight®488 Conjugated Goat Anti-Rabbit IgG (BA1127) was used as secondary antibody at 1:100 dilution and incubated for 30 minutes at 37°C. The section was counterstained with DAPI. Visualize using a fluorescence microscope and filter sets appropriate for the label used.

Figure 4. Flow Cytometry analysis of THP-1 cells using anti-DLL1 antibody (A02513-1).
Overlay histogram showing THP-1 cells stained with A02513-1 (Blue line). To facilitate intracellular staining, cells were fixed with 4% paraformaldehyde and permeabilized with permeabilization buffer. The cells were blocked with 10% normal goat serum. And then incubated with rabbit anti-DLL1 Antibody (A02513-1,1μg/1x10⁶ cells) for 30 min at 20°C. DyLight®488 conjugated goat anti-rabbit IgG (BA1127, 5-10μg/1x10⁶ cells) was used as secondary antibody for 30 minutes at 20°C. Isotype control antibody (Green line) was rabbit IgG (1μg/1x10⁶) used under the same conditions. Unlabelled sample without incubation with primary antibody and secondary antibody (Red line) was used as a blank control.